Downdraft Operation; Care Recommendations - Wolf ICBDD36 Guía De Uso Y Mantenimiento

DOWNDRAFT OPERATION

Downdraft Operation
CONTROL MODULE
To activate the downdraft, press the button. The
1
drowndraft chimney will elevate and the blower will turn
on automatically to low speed. Refer to the illustration
below.
To adjust the blower speed, press the , or
2
button. The corresponding LED will illuminate to indicate
blower setting.
To initiate boost mode, press and hold the button
3
for 5 seconds. Boost increases airflow by approximately
20% more than high but is limited to 10 minutes. After
10 minutes, the blower will automatically transition to
high.
DELAY FEATURE
The delay feature continues blower operation for approxi-
mately five minutes after use, then automatically turns off.
If the blower was operating on high or medium speed,
the blower will transition to the next lowest setting for five
minutes before turning off. The chimney will stay up until the
button is pressed.
FILTER INDICATOR
After approximately 30 hours of operation, the LED will
illuminate to indicate filters need to be cleaned. Refer to
care recommendations on page 4.
To reset the filter indicator, press the button. Refer to the
illustration below.
Control module.
|
4 English
CONTROL MODULE BUTTONS
DELAY MEDIUM
FILTER LOW
HIGH+ UP/DOWN
Filter Removal
To remove filters, push down on the filter while pulling the
filter forward and away from the downdraft. Refer to the
illustration below. Reinstall using the reverse procedure.
The filters are dishwasher safe. Refer to care recommenda-
tions on page 4.
IMPORTANT NOTE: Do not operate the downdraft without
filters.
Filter removal.

CARE RECOMMENDATIONS

Care Recommendations
CLEANING
Stainless Use a nonabrasive stainless steel cleaner and
steel apply with a soft lint-free cloth. To bring out the
natural luster, lightly wipe surface with a water-
dampened microfiber cloth followed by a dry
polishing chamois. Always follow the grain of
stainless steel.
Control Use spray degreaser to remove fingerprints and
module food soil. Spray on a cloth before wiping panel.
IMPORTANT NOTE: Do not spray cleaners
directly on the control module.
Filters Place filters and filter covers into the dishwasher
at approximately 160°C, or hand wash using a
biodegradable detergent.