Kit Assembly - Metra 99-8210 Instrucciones De Instalación

DIN radio provision with pocket
1. Remove the metal DIN sleeve from
the aftermarket radio.
2. Slide the sleeve into the Radio
Housing and secure by bending
the metal locking tabs outward.
(Figure A)
3. Slide the radio back into the sleeve
until it clicks in. (Figure B)
4. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the unit for proper operation.
5. Reassemble the dash in reverse
order of disassembly.

Kit Assembly

(Figure A)
(Figure B)
99-8210
ISO DIN radio provision with pocket
1. Remove the metal DIN sleeve and
trim ring from the aftermarket
radio.
2. Mount the ISO brackets to the
radio with the screws supplied
with the radio. (Figure A)
3. Slide the radio into the radio
housing until the side clips engage.
Snap the ISO trim plate into the
radio housing. (Figure B)
4. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the unit for proper operation.
5. Reassemble the dash in reverse
order of disassembly.
3
(Figure A)
(Figure B)