Kit Assembly - Metra 99-7614 Instrucciones De Instalación

ISO DIN radio provision with pocket
1.
Remove the metal "DIN" sleeve
and trim ring from the aftermarket
radio.
2.
Mount the brackets to the housing
with the supplied (4) 3/8" Phillips
screws. (Figure A)
3.
Slide the radio into the bracket/
housing assembly and secure
using the screws supplied with the
radio. (Figure B)
4.
Locate the factory wiring harness
and antenna plug in the dash.
Metra recommends using the
proper mating adapters from Metra
and/or AXXESS.
5.
Reassemble dash in reverse order
of disassembly.

Kit Assembly

(Figure A)
(Figure B)
99-7614
Double DIN radio provision
1. Mount the factory brackets to the
sides of the radio using the screws
supplied with the radio. (Figure A)
NOTE: 99-7614 brackets can
be used in place of factory
brackets.
2. Locate the factory wiring harness
and antenna plug in the dash.
Metra recommends using the
proper mating adapters from
Metra and/or AXXESS.
3. Place the DDIN trim plate on the
front of the DDIN radio. (Figure B)
4. Reassemble dash in reverse order
of disassembly.
7
(Figure A)
(Figure B)