Din Head Unit Provision - Metra 99-3033 Instrucciones De Instalación

DIN head unit provision

1. Slide the DIN cage into the Radio
Housing and secure by bending the
metal locking tabs down. (Figure A)
2. Slide the after-market head unit into the
cage and secure. Snap trim plate into
the radio housing.
3. Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adapter from Metra or
AXXESS. Re-connect the negative
battery terminal and test the unit for
proper operation.
4. Reassemble dash in reverse order
of disassembly.
5. Mount the support plate assembly to
the sub-dash with (4) hex-head screws
previously removed on page 1. (Be sure
the rear support bullet engages the rear
support bracket in the dash). (Figure B)
Kit Assembly 99-3033
5
(Figure A)
(Figure B)