Din Radio Provision With Pocket - Metra 99-8204 Instrucciones De Instalación

Radio housing preparation
1. Attach the pocket to the
back of the radio housing (by
holding the housing upside-down,
inserting the right edge of the
pocket into place and pushing the
rest of the pocket onto the lip) and
mount with (2) #8 x 3/8" Phillips
pan head screws supplied.
Kit Assembly 99-8204
2. Secure the mounting brackets to
the pocket with (8) #6 x 1/4" Phillip
flat head screws supplied.
3. Mount the rear support bracket to
the back of the pocket with (2) #8
x 3/8" Phillips pan head screws
supplied.
Continue to kit assembly

DIN radio provision with pocket

1. Slide the DIN cage into the radio
housing and secure by bending the
metal locking tabs down. (Figure A)
2. Slide the aftermarket radio into the
cage and secure. (Figure A)
3. Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapter from
(Figure A)
3
Metra or AXXESS. Re-connect the
negative battery terminal and test
the radio for proper operation.
4. Reassemble dash in reverse order
of disassembly.