Kit Assembly - Metra 99-8215 Instrucciones De Instalación

HVAC harness wiring
The included harness will retain the climate control information, is pre-wired for
the AXXESS ASWC-1 (sold separately), and will retain the factory 3.5mm AUX input.
Connect the Red wire to accessory power, and the Black to wire to ground when
using the AXXESS ASWC-1.
99-8215

Kit Assembly

DIN radio provision
1. Remove the metal "DIN" sleeve
from the aftermarket radio.
2. Slide the DIN sleeve into the Radio
Housing and secure by bending the
metal locking tabs down. (Figure A)
3. Slide the radio back into the sleeve
until it clicks in. (Figure B)
4. Locate the factory wiring harness
and antenna plug in the dash and
make all necessary connections
to the radio. Metra recommends
using the proper mating adapters
from Metra and/or AXXESS.
5. Mount the new radio assembly into
the dash and reassemble the dash
in reverse order of disassembly.
3
(Figure A)
(Figure B)