Fagor Edesa LE21S Manual De Instalacion Y Uso página 57

FITTING BUILT-IN DISHWASHERS
To install an integrated
model dishwasher:
a
If the worktop is made
of wood, place the
plastic protection on
it to prevent steam
damage.
Place the front brac-
b
kets on the dishwas-
her to fit it to the cup-
board.
Position the dishwas-
c
her in its space and
adjust the height of
the legs as shown in
the POSITIONING
chapter 4.
d Using the supplied
brackets, level the
control panel height
with the height of the
kitchen cupboard
drawer.
Put the template in
e
position and mark the
position of the holes.
Drill with a 2.5 mm
f
diameter bit and
screw the supports
(curved side up) to
the door.
g Take the door door
and fit the supports in
the recesses in the
door. Pull upwards
until it comes into con-
tact with the control
panel and ensure that
it is firmly in place.
I M P O R TA N T
The maximum and minimum recommended weights for the door cover to be
fitted on the dishwasher are as follows: Maximum: 7.84 kg Minimum: 2.87 kg
a
c
d
f
g
English
b
c
e
g
h
59