HP OFFICEJET 4610 Guía De Instalación Inicial página 19

Set up wireless (802.1 1) communication
Step 2: Test the wireless connection
To test the wireless connection and make sure it is
working properly, complete the following steps:
1. Make sure the printer is turned on and paper is
loaded in the tray.
2. On the printer control panel, press the
(Wireless) button.
3. Using the buttons on the right, scroll to and select
Print Reports, and then select Wireless Test
Report.
Change the connection type
After you have installed the HP software and connected the printer to your computer or to a network, you can
change the connection type.
•
To change from a wireless connection to a USB connection, connect the USB cable to the printer.
•
To change from a USB connection to a wireless connection, follow the instructions for your operating system.
Windows
1. On the computer desktop, click Start, select
Programs or All Programs, click HP, select
your printer name, and then click Printer
Setup & Software.
2. Click Convert a USB connected printer to
wireless.
3. Follow the display instructions to complete
the setup.
The printer prints a report with the results of the test. If
the test fails, review the report for information on how
to fix the problem and rerun the test.
For additional troubleshooting information, see
"Wireless (802.1 1) setup problems" on page 23.
Mac OS X
1. Open HP Utility. (HP Utility is located in the
Hewlett-Packard folder in the Applications
folder at the top level of the hard disk.)
2. Click Applications on the toolbar.
3. Double-click HP Setup Assistant, and then
follow the onscreen instructions.
19 19