Assembling Your Auto-Spiralizer - Ninja Intelli-Sense CT682SP Serie Manual Del Usuario

ASSEMBLING YOUR
AUTO-SPIRALIZER™
IMPORTANT: Review all
warnings on pages 3–6
before proceeding.
IMPORTANT: As a safety
feature, if the Spiralizer
Bowl and Feed Chute Lid
are not properly installed,
the timer will display "- --"
and the motor will be
disabled.
NOTE: To fit properly, the tabs
on the sides of the Blade Disc
must align with the gaps on
the top of the Collecting Bowl.
NOTE: The Spiralizer
accessory is only intended
for processing of fruit and
vegetables. Processing hard
ingredients such as cheese,
meats, and dried foods is not
recommended.
1
Place the unplugged motor
base on a clean, dry, and
level surface such as a
countertop or table. Press
downward on the motor
base to adhere the suction
cups to the work surface.
Plug the motor base into a
wall outlet.
25
1-877-646-5288
2 Lower the Spiralizer Bowl
onto the motor base.
3 Rotate the Spiralizer Bowl
clockwise until it clicks into
place.
4 Place the Collecting Bowl inside the
Spiralizer Bowl, aligning it over the gear post.
5 Choose your Blade Disc, making sure to
handle it carefully.
6 Install the Blade Disc onto the top of the
Collecting Bowl. The rim of the Blade Disc
should sit flush against the top of the bowl,
and the tabs on the sides of the Blade
Discs must align with the slots on the top
of the Collecting Bowl.
7 Assemble the Feed Chute Lid on top of
the Spiralizer Bowl. Turn the lid clockwise
onto the Spiralizer Bowl, aligning the gray
tabs on the lid with the front of the bowl.
When the unit is connected to power and
the container is correctly assembled onto
the motor base, press the Power symbol to
turn unit on. The GO button will illuminate,
indicating that the unit is ready for use.
n i n j a k i tc h e n . c o m
26