Using Your Total Crushing Blender Pitcher - Ninja Intelli-Sense CT682SP Serie Manual Del Usuario

USING YOUR TOTAL CRUSHING®
BLENDER PITCHER
IMPORTANT: Review all
warnings on pages 3–6
before proceeding.
TIP: If the Stacked Blade
Assembly is not fully
seated, you will not be
able to install and lock the
lid into position.
TIP: To learn more about
the unit's programs, refer
to page 10.
NOTE: Pre-set programs
have pauses and changes in
speed throughout the cycle.
NOTE: DO NOT add
ingredients before completing
installation of the Stacked
Blade Assembly.
1
NOTE: The pitcher can only Place the unplugged motor
base on a clean, dry, and
be installed in one orientation.
level surface such as a
The handle must be
countertop or table. Press
positioned on the front-right
downward on the motor
corner of the motor base to
base to adhere the suction
operate the appliance.
cups to the work surface.
Ensure the motor base is
connected to power.
13
1-877-646-5288
2 Lower the Total Crushing
Blender pitcher onto the
motor base. The handle
should be aligned slightly
to the right and the pitcher
should be oriented so the
LOCK symbols are visible
on the motor base. Then
rotate the pitcher clockwise
until it clicks into place.
3 Exercising care, grasp the 5 Place the lid on the pitcher, aligning the triangle symbol
Stacked Blade Assembly located on the lid with the triangle symbol located on the
by the top of the shaft and pitcher's handle. Press down on the handle until it clicks
place it onto the drive gear into place. The triangle symbols MUST be aligned for the lid
inside the pitcher. Note to lock onto place and the unit to operate. When the unit is
that the blade assembly connected to power and the container is correctly locked
will fit loosely onto the into the motor base,
drive gear. on. The available program buttons will illuminate and the
unit will be ready for use.
4 Add ingredients, making
sure to not exceed the
Max Fill line marked on the
side of the pitcher.
press the Power symbol to turn unit
14
n i n j a k i tc h e n . c o m