Continuity Check; Diode Test - koban KMIR-01 Manual De Instrucciones

KMIR-01

4.6. Continuity Check

WARNING: To avoid electric shock, disconnect power to the unit under test and discharge
all capacitors before taking any resistance measurements.
Remove the batteries and unplug the line cords.
• Set the function switch to the Ω CAP
• Insert the black test lead banana plug into the negative COM jack. Insert the red test
lead banana plug into the positive jack.
• Press the MODE key to switch the continuity functions.
• If the resistance is less than approximately 50Ω, the audible signal will sound. If the
circuit is open, the display will indicate "OL".
14
EN
position.
EN

4.7. Diode Test

• Set the function switch to the Ω CAP
• Insert the black test lead banana plug into the negative COM jack and the red test lead
banana plug into the positive V jack.
• Press the MODE key to switch the Diode functions.
• For ward voltage will typically indicate 0.400 to 3.000V.
Reverse voltage will indicate "OL". Shorted devices will indicate near 0V and an open
device will indicate "OL" in both polarities.
KMIR-01
position.
15