Resistance Measurements; Continuity Check - koban KMD-13 Instrucciones Operativas

KMD-13
AUTORANGING MULTIMETER

RESISTANCE MEASUREMENTS

WARNING: To avoid electric shock, disconnect power to
the unit under test and discharge all capacitors before
taking any resistance measurements. Remove the
batteries and unplug the line cords.
1. Set the function switch to the
2. Insert the black test lead banana plug into the negative
(COM) jack and the red test lead banana plug into the
positive jack.

3. Touch the test probe tips across the circuit or part under
test. It is best to disconnect one side of the part under
test so the rest of the circuit will not interfere with the
resistance reading.
4. Read the resistance in the display. The display will
indicate the proper decimal point, value and symbol.

CONTINUITY CHECK

WARNING: To avoid electric shock, never measure
continuity on circuits or wires that have voltage on them.
1. Set the function switch to the
2. Insert the black lead banana plug into the negative (-)
22
 position.

position.
www.grupotemper.com