Resistance Measurements; Continuity Check - koban KMDS01 Instrucciones Operativas

KMDS01
AUTORANGING MULTIMETER

RESISTANCE MEASUREMENTS

WARNING: To avoid electric shock, disconnect power to the
unit under test and discharge all capacitors before taking any
resistance measurements. Remove the batteries and unplug the
line cords.
1. Set the function switch to the
2. Insert the black test lead banana plug into the negative (COM)
jack and the red test lead banana plug into the positive
3. Touch the test probe tips across the circuit or part under test. It
is best to disconnect one side of the part under test so the rest
of the circuit will not interfere with the resistance reading.
4. Read the resistance in the display. The display will indicate
the proper decimal point, value and symbol.

CONTINUITY CHECK

WARNING: To avoid electric shock, never measure
continuity on circuits or wires that have voltage on them.
1. Set the function switch to the
2. Insert the black lead banana plug into the negative (-) jack
14
.
 position.

position.
www.grupotemper.com
jack.
