Functions During The Dive With Mb Levels; Level Stop Information - Scubapro Aladin 2G Manual De Usuario

6. Diving with microbubble (MB) levels
MB level is shown by pressing 2x
If however a level stop is ignored, the new
MB level is shown (->41).
)
NOTE:
MB levels have an influence on the
dive planner.
6.4 Functions during the dive
with MB levels

6.4.1 Level stop information

MB no-stop time
While diving with MB levels L1 to L5
Aladin 2G will display the MB no-stop time
instead of the ordinary no-stop time. Within
the MB no-stop time no level stops are
required.
"NO STOP" and the MB level symbol
are visible. The remaining MB no-stop time
is shown in minutes.
DEPTH
MB no-stop time
)
NOTE:
• Information and alarms for MB
no-stop time and ordinary no-stop
time are the same (->27).
• No-stop time relative to L0 is shown
by pressing 3x
(see )
• Regardless of the MB level, we
generally recommend to perform
a slow ascent during the last few
metres / feet.
40
. Level stop
Level stop icon
On entering the level stop phase, "NO
STOP" disappears and the arrow
appears. The
seconds and an audible attention beep
goes off. To complete the dive without
cascading to a lower MB level, all requested
level stops must be observed.
The deepest level stop is displayed in
DIVE TIME
metres (feet). The display "2: 3m " ("2:
10ft") means that a level stop of 2 minutes
at a depth of 3 metres (10 feet) has to be
NO STOP
observed. Deco information relative to L0
is shown on an alternate display (see
When a level stop has been finished, the
next higher level stop – if present – is
displayed. When all level stops have been
observed, the arrow
"NO STOP" reappears. The indication of
time shows the MB no-stop time again.
Nitrogen loading bar
relative to L0
DEPTH
DIVE TIME
NO
STOP
CNS O
2
Level stop
Deepest level
duration stop depth
arrow flashes for 8
STOP
extinguishes and
STOP
4s
DEPTH DIVE TIME
STOP
CNS O
2
Level stop ignored
%
Total time
of ascent
STOP
).
%
SCUBAPRO ALADIN 2G