Scubapro Aladin 2G Manual De Usuario página 137

1. Confirm that you wish to change the
depth of the alarm or to switch it on or
off by pushing
to flash.
2. Change the depth in increments of
1 m/5 ft by pushing
3. Confirm the selected depth with
"On" or "Off" starts to flash.
4. "On" indicates "activated", "Off"
indicates "deactivated".
switches between "On" and "Off".
Confirm the selected status with
See also page 23.
Setting the dive time alarm
DEPTH
Status
1. Confirm that you wish to change the
time of the dive time alarm or to switch
it on or off by pushing
time starts to flash.
2. Change the alarm time in increments of
5 minutes by pushing
3. Confirm the selected alarm time with
. "On" or "Off" starts to flash.
4. "On" indicates "activated", "Off"
indicates "deactivated".
Switch between "on" or "off" by
pressing
Confirm the selected status with
See also page 23,23.
Setting the safety stop duration
Duration of the safety stop
SCUBAPRO ALADIN 2G
. The depth starts
or .
.
.
DIVE TIME
Alarm time
. The alarm
or .
.
.
1. Confirm that you wish to change the
duration of the safety stop by pushing
. The duration starts to flash.
2. Change the duration in increments of
1 minute or to off (inactive) by pushing
or .
3. Confirm the selected duration with
.
Setting the maximum partial pressure
of oxygen (ppO max)
2
1. Confirm that you wish to change the
ppO max by pushing
2
rent value starts to flash.
2. Change the value in increments of
0.05bar by pushing
3. Confirm the selected value with
The ppO max setting is valid for gas 1 and
2
the deco gas.
Setting the time limit to reset the O
mix to air
Time limit to reset O mix to air
2
1. Confirm that you wish to change the
time limit of the reset by pushing
The current setting starts to flash.
2. Change the time limit by pushing
or .
(1 - 48hrs or no reset: "– – h")
3. Confirm the selected value with
11. Settings
ppO max
2
. The cur-
or .
.
%
2
.
.
59