Appendix; Technical Information; Maintenance; Replacing The Battery - Scubapro Aladin 2G Manual De Usuario

12. Appendix

12. APPENDIX

12.1 Technical information

Operating altitude: with decompression
information: sea level up to approx. 4000m
(13 000ft); without decompression (gauge
mode): unlimited.
Max displayed depth: 120m (395ft),
resolution between 0.8m and 99.9m:
0.1m, >99.9m: 1m. The resolution in feet
is always 1 foot.
Decompression
range: 0.8 to 120m (3 to 395ft)
Maximum environment pressure: 13bar
(189psi)
Clock: Quartz clock, time, date, dive time
display up to 199 minutes.
O concentration: Adjustable between
2
21%O (compressed air) and 100% O
2
Operating temperature: -10° to +50°C
(14°F to 122°F).
Power supply: CR2450, recommended
brands: PANASONIC,
RENATA, ENERGIZER, SONY, VARTA.
Life of the battery: 2-3 years or 200-300
dives. Actual life of the battery depends on
the quantity of dives per year, the use of
the backlight and the length of the dives. In
cold water the life of the battery is reduced.
Not all CR2450 batteries are the same, and
low quality batteries can have very short
life.

12.2 Maintenance

Aladin 2G is virtually maintenance free.
All you need to do is to rinse it carefully
with fresh water after each use and to
have the batteries changed when needed
->68. To avoid possible problems with your
Aladin 2G, the following recommendations
will help assure that it will give you years of
trouble free service:
WARNING
• Avoid dropping or jarring your Aladin 2G.
• Do not allow your Aladin 2G to be exposed to
direct, intense sunlight.
• Rinse your Aladin 2G thoroughly with fresh
water after each dive.
• Do not store your Aladin 2G in a sealed
68
• If there are problems with the water contacts,
• Do not clean Aladin 2G with liquids
• Check the battery capacity before each dive
• If the battery icon appears, replace the
calculation depth
• Diving with a weak battery: Aladin 2G may
• On the surface: if service icon and error
2
DURACELL,

12.2.1 Replacing the battery

(Use only the original SCUBAPRO battery
kit with O-ring.)
Removing the battery clears all physiological
data including saturation. This means that
for a repetitive dive the computer will not
compute correctly. Diving after replacing the
battery when there is desaturation time left
on the computer can lead to serious injury or
death from decompression sickness.
Change the battery only under these
conditions:
• After a dive if you know you will not be
• Before a dive if there is no desaturation time
container; make sure there is free
ventilation.
use soapy water to clean Aladin 2G and dry
it thoroughly. The surface of your Aladin 2G
housing can be treated with silicone grease.
Do not apply grease to the water contacts!
containing solvent (apart from water).
->16.
battery ->68.
stop working during the dive, service icon
and error code "E3" or "E6" appear. Close
the dive and replace the battery ->68.
code "E3" appear, replace the battery ->68.
All error codes other than E3: Aladin 2G must
not be used for any further dives. Take your
dive computer to an authorized SCUBAPRO
UWATEC dealer.
WARNING
diving, flying or going to higher altitude for
the next 48 hours.
left on the computer.
SCUBAPRO ALADIN 2G