Warnings; Anglais; Inglés; Battery Warning - Angelcare AC017 El Manual Del Propietario

OWNER'S MANUAL
KEEP YOUR OWNER'S MANUAL FOR FUTURE REFERENCE.
PLEASE READ THE WARNINGS AND INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING & USING THE PRODUCT.
FAILURE TO FOLLOW THE WARNINGS AND THE INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH OR DAMAGES TO THE PRODUCT.
THE SENSOR PAD FEATURE IS NOT FOR USE WITH ADULTS, CHILDREN OR INFANTS OLDER THAN 24 MONTHS.
THE SENSOR PAD IS NOT INTENDED TO BE USED TO DETERMINE IF A CHILD IS OUT OF THE CRIB.
WARNING
Adult assembly required.
Keep small parts away from children when assembling.
We, at Angelcare , stand behind all of our products.
®
If you are not completely satisfied or have any questions,
United States and Canada: Please contact us at:
angelcare@cdecinc.ca
Other countries: Please contact your local distributor.

WARNINGS

WARNING -
• KEEP the Nursery unit out of the reach of children more than 3 feet or 1 meter away.
• This product is NOT a Toy. NEVER allow children to play with it.
1. THIS PRODUCT CANNOT REPLACE RESPONSIBLE ADULT SUPERVISION. This
product is designed to aid in the monitoring of your child. When using the
monitor, you must still provide the supervision necessary for the continued
safety of your child. Monitoring of premature babies, or those considered
to be at risk, should always be carried out under the supervision of a health
professional. This monitor SHOULD NOT be used as a medical device, nor as
a device to prevent Sudden Infant Death Syndrome (SIDS).
2. ALWAYS be sure to immediately check on baby whenever an alarm sounds.
3. DO NOT use monitor near water (such as bath tub, sink, etc.).
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT EXPOSE TO RAIN OR MOISTURE
4. Keep monitor AWAY from heat sources (such as stoves, radiators, etc.).
5. ALWAYS place the Nursery Unit on a flat surface in an upright position
and allow for proper ventilation. DO NOT place on sofas, cushions, beds,
etc. which may block ventilation.
6. This product contains small parts. Adult assembly required. Exercise
care when unpacking and assembling the product and keep small parts
away from children.
7. When using the monitor, the room temperature should be between 50°F
and 104°F (10 °C and 40 °C).

BATTERY WARNING

8. The Wireless Sensor Pad battery is a replaceable Button Cell Lithium
battery. Only use the Angelcare
Danger of explosion if the wrong battery is used or if replaced incorrectly.
Refer to your user manual for correct battery installation. DO NOT short
circuit supply terminals. Remove the batteries from your Nursery Unit
and Sensor Pad if product is to be stored for an extended period of time.
Dispose of batteries according to your local ordinances. The Button cell
battery represents a small part and a choking hazard. ALWAYS keepall
batteries away from children.
9. IMPORTANT SAFETY INSTRUCTIONS
9.1 Heed all warnings – All warnings on the product and in the operating
instructions should be adhered to.
9.2 Follow all instructions – All operating and use instructions should
be followed.
9.3 Water and moisture - DO NOT use this apparatus near water. For
example, near a bath tub, wash bowl, kitchen sink, laundry tub, in a wet
environment or near a swimming pool and the like. Care should be taken
so that objects DO NOT fall onto units and that liquids are not spilled into
either unit or Sensor Pad through its openings.
2
DO NOT OPEN
recommended replacement battery.
®
FCC AND IC REGULATIONS
RF radiation exposure statement
The Nursery Unit complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. Caution: To maintain the compliance with the FCC's and
Industry Canada's RF exposure guideline, install the Nursery Unit at least 7.9" (20 cm)
from ALL persons. The transmitter of this device must not be co-located or operating
in conjunction with any other antenna or transmitter.
Industry Canada
This product meets the applicable Industry Canada technical
specifications. CAN ICES-3 (B)/NMB-3 (B)
9.4 Cleaning - Disconnect all units before cleaning. DO NOT immerse in
water any part of the monitor. Clean only with dry cloth.
9.5 Ventilation - DO NOT block any ventilation openings. Allow for proper
ventilation when units are in use. DO NOT cover the Nursery Unit with any
object such as a blanket. DO NOT place it in a drawer or in any location
which would muffle the sound or interfere with the normal flow of air.
9.6 Heat sources - DO NOT install near any heat sources such as radiators,
heat registers, stoves, TVs or other apparatus (including amplifiers) that
produce heat. Heat can damage the case or electrical parts.
9.7 Accessories - Only use attachments/accessories specified by the
manufacturer. DO NOT place this product on an unstable cart, stand,
tripod, bracket or table. The product may fall, causing serious injury to a
child or adult and serious damage to the product. Use ONLY with a cart,
stand, tripod, bracket or table recommended by the manufacturer or
sold with the product. Any mounting of the product should follow the
manufacturer's instructions.
9.8 Servicing - DO NOT attempt to service this product yourself as opening
or removing covers (except battery door) may expose you to dangerous
voltage or other hazards.
9.9 Replacement parts - When replacement parts are required, be sure
the replacement parts specified by the manufacturer have the same
characteristic as the original part. Unauthorized substitution may result
in fire, electric shock or other hazards.
9.10 Usage - This baby monitor is intended as an aid. It is NOT a substitute
for responsible and proper adult supervision and should not be used as
such. Use this appliance ONLY for its intended use as described in this
manual.
9.11 Object and Liquid Entry - NEVER push objects of any kind into this
product through casing slots as they may touch dangerous voltage points
or short out parts that could result in a risk of fire or electric shock. NEVER
spill liquid of any kind on the product.
9.12 Vibration Source - When the monitor is in use, DO NOT use a
crib mobile or other crib accessories that may produce vibrations.
Other sources of vibrations may include fans, washing machines,
loud music, etc. These sources of vibration may interfere with the
performance of your Angelcare
if it continues to detect any movement other than your baby's. Be
sure all vibration sources are eliminated before using the monitor.
You may experience false alarms for several reasons. The most
common reason is the Nursery Unit has not been turned OFF after
you have removed your baby from the crib. Another reason is the
Sensor Pad has not been placed under the mat tress properly.
Be sure the Sensor Pad is on a flat, firm surface with the Angelcare
side facing up. The sensitivity level may also need to be adjusted. Refer
to Step 4.3. Always be sure to immediately check on baby whenever
an alarm sounds.
9.13 Sensor Pad - Your Sensor Pad can be used in any crib that is stationary.
If the crib has a spring or slat base, place a hard board between the crib
base and the Sensor Pad measuring at least 13'' x 13'' (33 x 33 cm) and
1/4'' (6 mm) thick. Only use your Angelcare
environment such as a crib where the Sensor Pad can rest on a completely
flat, firm surface. The Sensor Pad is made of plastic and does not permit
monitor and the alarm will not sound
®
monitor in a stationary sleeping
®
logo
®