Getting To Know Your Monitor - Angelcare AC017 El Manual Del Propietario

Ocultar thumbs Ver también para AC017:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

STEP 4 - GETTING TO KNOW YOUR MONITOR
4.1 TESTING THE SENSOR PAD:
1
MOVEMENT ALARM
If NO movement is detected after 15 seconds you will hear
a single pre-alarm sound from the Nursery Unit.
If after a further 5 seconds there is still NO movement
detected, Nursery Unit speakers will emit loud continuous
beeps.
TO STOP THE ALARM
IMPORTANT
• Test your monitor before first use.
• Test your monitor regularly to ensure it is functioning correctly.
• Test your monitor every time you move the Sensor Pad to a different place.
4.2 PAUSING AND RESTARTING THE SENSOR PAD:
Allows you to pause the Sensor Pad if you remove baby from the crib, e.g. for feeding or comforting.
IMPORTANT
• If you do not pause the Sensor Pad, the alarm will sound if there is no movement after 20 seconds.
• Ensure to unpause the Sensor Pad before putting baby in the crib.
6
2
Place your hand back
on the mattress.
1) From the Nursery Unit, press the Pause button on the top right of
1
the unit.
2) The light will flash white when the Sensor Pad is paused. The Nursery
Unit will emit a single beep every 20 seconds to indicate movement
function is paused.
2
3) To unpause the Sensor Pad press the Pause button again.
1) Move your hand lightly on the mattress.
2) Remove your hand from the mattress. After 15
seconds you will hear a pre-alarm sound and
the light will flash red.
3
3) 5 seconds later the alarm will emit a loud
continuous beeps and the light will flash red
continuously.
IF THE ALARM DOES NOT SOUND
Avoid contact with crib while Sensor Pad is in
operation.
Place crib near a supporting wall.
Adjust Sensor Pad sensitivity level.
Turn OFF crib mobile, fans, loud music or anything
else that may cause vibration.
OR
Press Pause
on the Nursery
Unit

Publicidad

Tabla de contenido
loading

Tabla de contenido