Mounting The Adapter - Metz Canon SCA 3102 M3 Manual Del Usuario

• = The camera supports this dedicated function.
x = Function must be set on the camera or is per-
formed by the camera.
◊ = Flash shots can be taken with all shutter speeds
of the camera. However, the shutter speed
should not be faster than 1/125s if the full guide
number or the maximum flash range of the
mecablitz are required for picture shooting!

1. Mounting the adapter

All units involved must be switched off before
mounting or dismounting the SCA adapter on
or from the mecablitz or the mecablitz on or
from the camera.
on the mecablitz 32 Z-2, 32 MZ-3, 40 MZ-.. and
50 MZ-5:
Turn the flash unit's foot by 90° (not with 50 MZ-5
and 70 MZ-..). Press the retention catch against
the casing, simultaneously pushing the hitherto
used standard foot or SCA adapter out of the guide.
Any cover plate that may still be in place (required
for the 301 standard foot or SCA 300 adapter)
should be gripped in the centre and withdrawn.
on the mecablitz 54 MZ-...:
Open the battery compartment cover, press the
retention catch at the lower end of the battery
compartment and simultaneously remove the
standard foot or SCA adapter. Any cover plate that
may still be in place (required for the 301 standard
foot or SCA 300 adapter) should be gripped in the
centre and withdrawn.
5