Electrolux EPI09NLIW Manual De Instrucciones página 23

into the unit, taking care that the left and right
into position.
Dust box
Push from this side
Frame
Clip
the frame of the Dust Collector.
Lift the dust box up
Frame
4 Put the dust box into the warm water with a small
amount of neutral detergent for ten minutes or
longer, then clean it with a soft brush. Rinse with
clean water after make sure the box is clean, dry
it completely, then install back to the frame of
dust collector.
frame and the two clips of dust box are securely
the power and circuit breaker are turned off
for at least 60 seconds.
Do not use high pressure air to blow plasma
dust collector so as to avoid accidental injury
and damage to the eyes and the collector.
Do not expose the collector directly under the
cause deformation and damage.
during the operation, and avoid vigorously
scrubbing the dust collector.
Do not use strong corrosive detergents to
clean the dust collector.
Ensure the dust collector is competely dried
before install it back to the indoor unit to avoid
electricity leakage.
Dust box
22