Steam Ironing; Dry Ironing - Rowenta AUTOSTEAM DZ1900 Manual Del Usuario

Steam Ironing

WARNING !
• Never iron or steam clothes while they are being worn.
• Before ironing for the first time fill iron and allow to heat.
• The iron should be allowed to emit steam for 1 to 2 minutes
while pressing the burst of steam button a few times to
remove any impurities. This should also be done if iron is
not used regularly.
Steam is only produced when the temperature dial is set to the
shaded area (after •• setting).
Warning! Never iron clothes while they are being worn.

Dry Ironing

steam
Auto Steam
Burst of steam
- This feature is ideal for removing stubborn
wrinkles or pressing in sharp creases in hori-
zontal use. When the temperature control is
set to the steam zone (after ••) the burst of
steam can be used by pressing the burst of
steam button. Leave an interval of 4 seconds
between bursts.
Vertical Steam
- The iron can also be used vertically.
- This is especially useful for getting creases
out of hanging clothes, curtains, tapestries, etc.
- To steam vertically, press the burst of steam
button while holding iron in the upright position.
- To iron without steam, slide the variable
control lever to the
- We recommend dry ironing with an empty
tank.
- Set the temperature for the type of material to
be ironed (•, •• or •••).
- For steam output to be automatically
adjusted to the soleplate temperature, turn
the steam control to the
position.
position.