FAAC SAFEzone RETROFIT KIT Guía Rápida De Inicio página 17

1. DESCRIPTION
The SAFEzone RETROFIT KIT can be fitted on arm operators for FAAC leaf gates - whether hydraulic
or electromechanical (except 412) - featuring a 230 V power supply.
With the use of both the
encoder, the kit makes it easy to bring previously installed systems up to code without the need to
replace existing automated systems.
The kit is fully compatible with existing systems that feature:
• Remote controls with 433 frequency and DS -
• Safety devices with N.C. contacts
• BUS-2EASY accessories
• FAAC rear brackets having the minimum length described in figure
COMPONENT
SAFECODER (2x)
E145
2. INSTALLATION
1. Remove the central images pullout from the instructions manual.
2. Carry out mechanical assembly as shown in figure
3. Wire the control board as shown in figure
4. Wire the encoders to the red terminal as shown in figure
5. Wire the system photocells with n.C. contact as shown in figure
for protection during closing, FSW OP: N.C. safety devices for protection during opening).
6. Power up the E145
7. Check the status of the leds on the
8. Depending on installation ensure that the encoder leds match those described in figure
9. Depending on the remote controls supplied with the system carry out memorisation.
10. Depending on the needs of the customer and the system set the control board as shown in section
3 (Set the parameter
11. With the leaves closed carry out operating time learning as shown in section 4.
12. Set the parameters listed in section 5 according to current regulations.
13. Implement an opening to verify that the system works correctly.
SAFEzone RETROFIT KIT
E145 control board and the new FAAC patented SAFECODER absolute
DESCRIPTION
Absolute encoder with BUS-2EASY communication
Control board with OMNIDEC (SLH/SLH LR, LC/RC, DS) integrated radio
decoding
board.
E145
EN=Y
).
LC/RC - SLH/SLH LR coding
.
(Ref. B).
board, as shown in figure
1
(pictures collection)
(FSW CL: N.C. safety devices
.
532037 - Rev. B
(Ref.A).