Cycle Programming - FAAC SAFEzone RETROFIT KIT Guía Rápida De Inicio

Display Advanced Function
t1
OUT 1 TIMING
You can adjust the timing of OUT 1 output if a timed function has been selected
with a time from
1
from to
o2
OUT 2:
You can set the output OUT2 (open collector N.O.).
See the options as
t2
OUT 2 TIMING
Adjustable as for
AS MAINTENANCE REQUEST - CYCLE COUNTER (linked to the subsequent
two functions):
You can enable the signaling of maintenance request, or the cycle counter.
Y
= enable the SIGNALING when the programmed number of cycles has
been reached (as defined in subsequent two functions
Signaling consists of a pre-flashing of 8 sec (in addition to the time
may already be set with the function
If using a PC/MAC a maintenance request is set with a number of
cycles greater than 99,990, the subsequent two functions
nd
no
= enable the CYCLE COUNTER, that will be displayed in the subse-
quent two functions
If the number of cycles performed is greater than 99,990 the subse-
quent two functions
nc

CYCLE PROGRAMMING

AS Y
If =
the signaling of maintenance request begins (can be set from
AS
If =
performed. The value displayed is updated with the succession of the cycles,
interacting with the value in
When
+
SAFEzone RETROFIT KIT
(visualised only with the function
1 59
to minutes in 1-minute steps for functions 03-14 and
59
sec in 1-second steps for function 11
o1
.
(visualised only with the function
t1
.
will display 99 and 99, respectively.
nc
nc
(THOUSANDS):
the display will show the number of thousands of cycles after which
no
the display will show the number of thousands of work cycles
nd
AS no
= you can reset the cycle counter: press simultaneously
and - for 5 sec.
o2
PF
) before each movement.
nd
and up to a displayed maximum of 99,990.
nd
and will display 99 and 99, respectively.
.
11
o1 03 o1 14
= or =
03 o2 14
= or =
nc nd
and
nc
and
0 99
to ).
532037 - Rev. B
Default
02
):
02
02
):
no
).
00