FAAC SAFEzone RETROFIT KIT Guía Rápida De Inicio página 28

Display Advanced Function
nd CYCLE PROGRAMMING
AS Y
If =
signaling of maintenace request begins (can be set from
AS no
If =
The value displayed is updated with the succession of the cycles,
interacting with the value in
e.g.: if the system has performed 11,218 cycles,
will be displayed
St AUTOMATED SYSTEM STATUS:
You can exit programming, choosing whether or not to save the configuration
you just performed.
1. set the choice:
Y
to SAVE and EXIT the programming
no
to EXIT the programming WITHOUT SAVING
2. press the button F to confirm; at the end the display returns to visualize
the automated system status:
00
= CLOSED
01
= OPEN
02
= Stationary then "OPENS"
03
= Stationary then "CLOSES"
04
= In "PAUSE"
05
= Opening
06
= Closing
WARNING If power is lost to the board prior to confirmation (step
2.), all changes made will be lost.
+
-/R2 F
SAFEzone RETROFIT KIT
(TENS):
the display will show the number of tens of cycles after which the
the display will show the number of tens of work cycles performed.
You can EXIT programming at any time: press and hold F and
then also - to switch directly to
nc
.
nc
07
= FAIL SAFE in progress
08
= checking BUS-2EASY
09
= Pre-flash then "OPENS"
10
= Pre-flash then "CLOSES"
11
= Emergency open
12
= Emergency close
HP
= Hold position
St
.
12
0 99
to ).
nd
= 11 and = 21
devices in progress
532037 - Rev. B
Default
00
Y