Tornado M Serie Manual Del Usuario página 8

MAINTENANCE
Once a month remove the motor cover and vacuum out any dust or debris which has accumulated on
the motor. Replace the motor cover by setting it overt the holes in the housing and replace all of the
screws. Check and maintain the tightness of all the fasteners.
WARNING: Do not over-tighten the switch housing screws.
Keep the machine clean especially at the handle tube and collar so the handle tube will move
freely through the collar. Inspect the cord for cuts, gashes, or loose prongs; replace as needed.
Disassembly of this motor voids the warranty. Improper disassembly and assembly of this motor can
permanently damage the field or rotor.
TROUBLESHOOTING
Problem
Machine will not start
Machine will not reach operating speed
Motor runs but pad or brush does not turn
Possible Cause
Circuit breaker has tripped (Allow the circuit breaker 2
minutes to cool before resetting).
Circuit breaker will not reset. Replace.
Switch is defective. Replace.
Cord is damaged. Replace.
Plug is broken or has a loose contact. Replace.
Over drawn circuit. Unplug anything other than the
machine from the circuit or locate another circuit.
Coupling is broken. Replace.
8