How To Operate The Machine; Transporting The Machine - Tornado M Serie Manual Del Usuario

HOW TO OPERATE THE MACHINE

First, install the pad driver and pad, brush, or
other attachment to be used. Plug the machine
in as directed and lower the handle to the desired
operating height and lock in place using the cam
lever handle. Push the safety switch forward
(see figure #3) and squeeze the switch triggers
beneath the handle grips. This activates the
motor and stars the block, brush or attachment in
operation. Each time your release the triggers the
safety switch will reset. You will need to follow the
direction above to restart the machine. CAUTION:
When leaving the machine unattended, disconnect
the wall plug and return the handle to the "locked"
upright position to prevent accidental starting.
Safety Switch
Switch trigger
Figure #3
TO GUIDE YOUR FLOOR MACHINE
To the Right: raise the handle slightly. The higher
the handle is lifted, the faster the machine will
move to the right. To the Left: lower the handle
until the machine moves to the left. The more the
handle is lowered the faster the machine will move
to the left.
TO INSTALL THE OPTIONAL SOLUTION TANK
Mount the solution tank to the front of the
handle and attach with mounting brackets and
knobs. Position the solution tank control handle
horizontally and below the switch lever of the
machine and adjacent to the right handle grip.
Remove the plug from the motor housing and
insert the (long) extension tube adaptor and
secure at bottom of machine with the retainer.
The solution tank should be used only with a
shower feed drive block or bush.

TRANSPORTING THE MACHINE

Place the handle in the upright position. Lock
the handle can release lever. Tip the machine
back and transport on the wheels.
7