Mic 70 Display Settings; Setting The Language On Mic; Settings For Working Mode - Kärcher MIC 50 Manual De Instrucciones

6.8.2 MIC 70 display settings

ATTENTION
Do not start the engine during the adjustment process.
The following settings can be selected or changed.
<Brightness>
<US Standard>
<Metric>
<Regeneration mode> Auto
<Date>
<Time>
<Language>
Navigation display
1
Display of time and date
2
Drive
3
Hydraulic oil temperature
4
Display for transport mode or working mode
5
Indication for travel direction preselection "reverse"
6
Travel speed display
7
Indication for travel direction preselection "forwards"
8
Warning lights / indicator lights
9
Engine cooling water temperature
10
Filling level of fuel tank
11
Engine speed
12
Display brightness
kPa
bar
Inhibit
Date and date format:
YYYY-MM-DD
DD.MM.YYYY
Time and time format
24 h
12 h
Language
Not all languages are available;
select the relevant language
available
ATTENTION
The menu item <Service> is reserved for authorised cus-
tomer service personnel.
Menu
1
Selection of <Settings> menu item
2
1. Switch on the ignition.
2. Press the function button for the menu and navigate to
<Settings>.
3. Use the function buttons on the navigation display to
navigate within the menu.
4. Select the settings.
5. Press <o>: Confirm selected setting.
6. Press <x>: Return / cancel.
7. Navigate to <Time> in order to set the time.
Setting the time
To save the time and date, the system has to be restarted.
8. Press <o>, the system will be restarted. Date and time
are saved.
9. Press <x> to cancel.

6.8.3 Setting the language on MIC 70

1. Switch on the ignition.
2. Press the function button for the menu and navigate to
<Settings>.
3. Confirm using the circle symbol <o>.
4. Use the <Arrow to right> function button to navigate to
the right-hand level.
5. Use the <Arrow down> function button to navigate to the
language.
6. Select the required language.
7. Switch off the ignition - the selected language is saved.

6.8.4 Settings for working mode

Note
When switching over from TRANSPORT MODE to
WORKING MODE (see chapter8.1 Operating programs
(not MDC variant)), the engine speed and speed settings
are changed.
English 63