Fitting The Attachment To The Vehicle - Kärcher MIC 50 Manual De Instrucciones

9.4.4 Fitting the attachment to the vehicle

Vehicle rear
1
Retaining pin with retaining clip (2x)
2
Attachment
3
Rear supports
4
Fixing hook (2x)
5
Front supports
6
1. Remove the retaining pins from the attachment frame to
the left and right (retaining pin and retaining clip are a
part of the attachment frame).
2. With the vehicle rear centred and parallel, (carefully)
drive under the attachment standing on supports as far
as you can go.
Interchangeable frame for the attachment
1
Fixing hook (2x)
2
Attachment frame
3
3. Cautiously lift the attachment frame until the front sup-
port feet come off the ground, whist making sure that the
fixing hooks engage in the attachment frame.
4. Finally, check the secure fit of the fixing hooks.
5. Remove the front supports from the attachment.
Attachment
1
Rear supports
2
Locking device for attachment (2x)
3
6. Get in, and completely lower the attachment frame.
7. Remove the rear supports from the attachment.
Retaining pin (2x)
1
Retaining clip (2x)
2
8. Secure the attachment to the left and right (retaining pin
and retaining clip are a part of the attachment frame).
During first installation or when changing the carrier ve-
hicle, the fixing must be set, see chapter 9.4.3 Setting
the fixing.
9. Deal with the hydraulic and electrical connections after
doing the fitting.
English 79