Mounting Options On The Attachment Frame; Setting The Fixing - Kärcher MIC 50 Manual De Instrucciones

Attachment frame with tipping function
1
1. The attachments are fitted on a Kärcher interchangea-
ble frame or on an integrated interchangeable frame
from the attachment manufacturer, and are fitted and
secured on the attachment frame.
Control lever
1
2. The attachment frame is controlled using the control le-
ver at the right of the joystick.
Switch for "double-acting control hydraulics AUX rear" /
1
"attachment frame with tipping function"
3. To activate, switch the switch over to "attachment frame
with tipping function".
78

9.4.2 Mounting options on the attachment frame

Mounted spreader
1
Interchangeable frame (integrated in the attachment)
2
Attachment frame with tipping function
3
1. Attaching / removing is described using the example of
a mounted spreader.

9.4.3 Setting the fixing

Note
The setting for the fixing of the interchangeable frame must
only be made during first installation or when fitting to an-
other carrier vehicle.
Screw with nut
1
Fixing hook (2x)
2
Attachment frame
3
1. Undo the nuts to the left and right by about 1 revolution.
2. Fit the attachment to the attachment frame and secure
it using retaining pins and retaining clips, see the follow-
ing chapter9.4.4 Fitting the attachment to the vehicle.
3. Completely lower the attachment frame.
4. Press the fixing hook against the attachment frame as
shown.
5. Re-tighten the nuts to the left and right.
English