Tempomat Mdc Variant; Preselection Of Speed (Mdc Variant); Selecting The Travel Direction; Driving - Kärcher MIC 50 Manual De Instrucciones

Deactivating Tempomat
3. The brake pedal has to be pressed or the inching pedal
stepped on in order to deactivate Tempomat. After de-
activating Tempomat, pressing RES (during the run) will
reactivate the previously saved speed.

8.3.4 Tempomat MDC variant

Tempomat switch
1
Activating Tempomat
1. Select the desired working speed using the accelerator.
2. If the vehicle moves at the required speed, push the
Tempomat switch. Tempomat is activated.
Deactivating Tempomat
3. To deactivate, the brake pedal must be pressed or the
Tempomat switch must be pressed.

8.3.5 Preselection of speed (MDC variant)

ATTENTION
The preselection of the speed may only be made when the
vehicle is at a standstill.
TRANSPORT MODE FAST:
1
The travel speed is regulated by the accelerator pedal.
Maximum speed approx. 30 km/h.
2 TRANSPORT MODE SLOW:
2
The travel speed is regulated using the accelerator.
Maximum speed approx. 15 km/h.
3 lever for preselecting the speed
3
1. Stop the vehicle.
2. Set throttle to engine rotation speed/throttle position
3. Select the desired speed using the lever (on the side
console on the right).

8.3.6 Selecting the travel direction

The travel direction selector switch can be found on the
joystick.
Note
If the driver leaves the driver's seat whilst the travel direc-
tion selector switch is in "forwards" or "reverse", then the
engine will switch off.
Travel direction selector switch
1
Indication for travel direction preselection forwards
2
Indication for travel direction preselection reverse
3
1. FORWARDS: The switch goes forwards; travel direction
FORWARDS will be activated and the indicator for trav-
el direction preselection "forwards" lights up.
The parking brake is automatically released in this posi-
tion.
2. REVERSE: The switch goes backwards; travel direction
REVERSE will be activated and the indicator for travel
direction preselection "reverse" lights up.
The parking brake is automatically released in this posi-
tion.
3. NEUTRAL: Switch setting is in the middle; a display
does not light up.
In this position, the parking brake is automatically actu-
ated; the vehicle does not move.

8.3.7 Driving

CAUTION
Risk of accident
Do not let go of the accelerator pedal abruptly during driv-
ing. The vehicle will be braked when the accelerator pedal
is released. The vehicle will be decelerated to a lesser ex-
tent when the accelerator pedal is released in transport
mode rather than in operating mode.
CAUTION
Risk of damage
Make sure that the vehicle does not become stuck when
driving over obstacles.
Drive over obstacles up to 150 mm slowly and carefully at
an angle of 45°.
Obstacles above 150 mm may only be driven over using a
suitable ramp.
CAUTION
Risk of accident
When driving on public roads for transport purposes (and
not when cleaning of public roads), switch off the PTO and
close the lowering choke for the front power lift.
1. Switch off the PTO.
2. Carefully press the accelerator.
3. Steer the vehicle using the steering wheel.

8.3.8 Stopping

1. Release the accelerator pedal.
English 73