Adjusting The Face- Grinding Rest (Figure 4); Adjusting The Belt Tracking; Changing The Grinding Belt (Figures 1 + 2) - Fein Grit GI1005V6 Serie Manual Del Usario

GI 100 (US).book Seite 10 Dienstag, 17. Februar 2009 1:04 13
en
7.3 Adjusting the face- grinding rest
(Figure 4).
The gap size must always be
WARNING
adjusted to the correct size. Thin
workpieces could be pulled into the machine
and cause severe or fatal injury.
For face grinding applications, the face- grinding
rest must be aligned parallel to the grinding belt
and must touch it over the complete surface.
Loosen the Star-knob bolt and remove the
top and the front protective cover.
Loosen screw and fold the side cover down.
Loosen the screws and adjust the gap size
between the stop and the face-grinding rest.
The gap size must not exceed 2 mm (max.)!
Tighten screws again.

7.4 Adjusting the belt tracking.

Switch the machine on only
briefly and check the belt track-
ing.
If the grinding belt moves left or
right, adjust the belt tracking
with the star-knob bolt until centred.
If the belt tracking cannot be adjusted centred:

8. Changing the grinding belt (Figures 1 + 2).

Before any work on the machine
WARNING
itself, pull the power plug from
the socket outlet.
Loosen the Star-knob bolt and remove the
top and the front protective cover.
Loosen screw and fold the side cover down.
Push belt tension lever down
to release the clamping device.
Remove the old grinding belt.
Before attaching the new grinding belt,
observe the information concerning the run-
ning direction on the inner side of the grind-
ing belt! It must correspond with the running
direction of the drive wheel.
Place the grinding belt both around the drive
wheel and around the contact wheel.
10
Shut the side cover and tighten screw again.
Reattach the front protective cover and
tighten the Star-knob bolt again.
Check the gap size at the stop. 2 mm (max.)
WARNING
max 2 mm
Adjustment screw
for face- grinding rest
Clean the drive wheel and the contact
wheel with compressed air.
Check the drive wheel and the contact
wheel for wear, deformation and damage.
Have damaged components replaced with-
out delay!
Push the belt tension lever up
again to tension the grinding
belt.
Shut the side cover and tighten screw again.
Reattach the top and the front protective
cover and tighten the Star-knob bolt again.
Check the gap size of the grinding rest.
Switch the machine on and adjust the belt
run.
GI 100
Fig. 4
Stop