Mounting Instructions; Electrical Connection (See; Intended Use Of The Machine; Adjustments - Fein Grit GI1005V6 Serie Manual Del Usario

GI 100 (US).book Seite 9 Dienstag, 17. Februar 2009 1:04 13
GI 100

4. Mounting instructions.

Before any work on the machine itself, pull the power plug from the socket outlet.
WARNING
Fasten the machine onto the GRIT GIXS or GIXBE undercarriage (see mounting
instructions). The fastening of both the undercarriage to the floor and the machine to the undercar-
riage must be suitable to withstand the forces occurring during working.
Use appropriate screw connections (size, length) for mounting.
5. Electrical connection (see appendix).
Hazardous Voltage
WARNING
Contact may cause electric shock or
burn.
The machine is not equipped with a
mains plug and must be connected to the power
supply. The electrical connection, which is to be
provided by customer, must be carried out by a
qualified electrician.

6. Intended use of the machine.

The machine is intended for stationary grinding of metal materials using manufacturer approved
grinding belts.

7. Adjustments.

Before any work on the machine itself, pull the power plug from the socket outlet.
WARNING

7.1 Adjusting the spark guard.

Loosen both wing bolts and adjust the spark
guard in such a manner that the grinding belt
is covered as far as possible.
Tighten both wing bolts again.

7.2 Adjusting the grinding rest (Figure 3).

The gap size must always be
WARNING
adjusted to the correct size. Thin
workpieces could be pulled into the machine
and cause severe or fatal injury.
Loosen star-knob bolt and adjust the gap
size to 2 mm (max.).
Tighten the star-knob bolt again.
Observe mains voltage: The mains voltage and
the frequency of the power source must agree
with the data on the type plate of the machine.
Before starting operation for the first time,
check the rotation direction of the motor. The
rotation direction may be changed only by a
qualified electrician.
Star-knob bolt for
grinding rest
en
Fig. 3
WARNING
max 2 mm
9