Control Set-Up Instructions; General Information; Control Set-Up Procedures - Whirlpool 3LCHW9100YQ Instrucciones De Instalación

Ocultar thumbs Ver también para 3LCHW9100YQ:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

1. Door must be closed before cycle selection is made.
2. Press fabric setting key pad for the wash cycle desired. After
the cycle is started, the time will display and count down.

General Information

Scrolling 'out of order' showing in display, followed by a
failure code
This condition indicates the washer is inoperative.
"0 Minutes" showing in display
This condition indicates the washer cannot be operated. If a door
switch fails, it must be replaced before normal operation can be
restored.
Cold Start (initial first use)
Washer is programmed at the factory as follows:
11-minute wash period
3 rinses (extra rinse not enabled)
Warm Start (after power failure)
A few seconds after power is restored, if a cycle was in progress
at the time of the power failure, "RESELECT CYCLE" will flash in
the display, indicating the need for a key press to restart washer.

CONTROL SET-UP INSTRUCTIONS

Control Set-up Procedures

IMPORTANT: Read all instructions before operating.
Set-up procedures can be entered by using the Service Access
Code (see "Service Access Code" section).
The washer is now in the set-up mode. The lower fabric setting
key pads and the digital display are used to set up the controls.
The display can contain 4 numbers and/or letters and a decimal
point. These are used to indicate the set-up codes and related
code values available for use in programming the washer.
How to use the key pads to program controls
1. The PERM PRESS key pad is used to adjust the values
associated with set-up codes. Pressing this key pad will
change the value by increments. Rapid adjustment is possible
by holding the key pad down.
2. The DELICATES/KNITS key pad advances you through the
set-up codes. Pressing this key pad will advance you to the
next available set-up code. Holding the key pad down will
automatically advance through the set-up codes at a rate
of 1 per second.
3. The QUICK CYCLE key pad is used to select or deselect
options.
Start Operating Set-up
Before proceeding, it is worth noting that, despite all of the
options available, an owner can simply choose to un-crate a new
semi-pro washer, hook it up, plug it in, and have a washer that
operates. Washers are preset at the factory for a 11-minute wash
period and 3 rinses (no extra rinse).
11

Publicidad

Tabla de contenido
loading

Tabla de contenido