Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Ch. 2 Getting Started
2 If a tape cassette is already installed and
you wish to replace it, remove it by pulling
it straight up.
3 If the ink ribbon is loose in the tape cassette
to be installed, use your finger to wind the
toothed wheel in the direction of the arrow
on the cassette until there is no slack in the
ribbon. Also, make sure that the end of the
tape feeds under the tape guides.
NOTE
☞
For stamp and AV label cassettes, the tightening
of the ink ribbon does not apply, since they are
not equipped with ink ribbons.
☞
If you are using a new tape cassette provided
with a stopper, be sure to remove the stopper.
4 Insert the tape cassette firmly into the tape
compartment, making sure that the entire
back of the cassette touches the bottom of
the compartment.
NOTE
When inserting the tape cassette, make sure that the
inner ribbon does not catch on the corner of the
metal guide.
5 Close the compartment cover, and then
press o to turn on the machine, if it is off.
The width of the currently installed tape is
shown by the tape width indicator on the
left edge of the display.
1 2 3 4 5 6 7 8 9
R
R
G
<<< P-touch >>>
R
N O
H
R
L M
R
I
1:_
R
J
AUTO
1.10
Length
Margin
6 Press f once to remove any slack in the
tape and cut off the excess.
8
K Q Q Q Q Q
A
B C D E F
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q
HELSINKI
A
AUTO
Font
Width
Size
Connecting the P-touch to a
computer
●
●
●
●
●
●
●
●
●
●
●
This machine is equipped with a USB port,
allowing you to use a USB cable to connect the
P-touch to a computer running Windows
Mac OS, and print labels created using the
P-touch Editor software.
To connect a computer to the P-touch
through the USB port:
1 Insert the flat (A) connector on the USB
cable into the USB port on the computer.
2 Insert the square (B) connector on the USB
cable into the USB port on the right side of
the P-touch.
3 Turn on the P-touch.
After the P-touch is connected to a computer
using a USB cable, the P-touch enters Interface
mode when data is sent to it from the computer.
NOTE
☞
To exit Interface mode for a USB connection
and return to the text, press any key.
☞
The P-touch cannot enter Interface mode for a
USB connection while it is printing, feeding
tape or in Interface mode for an RS-232C con-
nection or while a macro is being assigned to a
PF key.
1 2 3 4 5 6 7 8 9 A B C D E F K Q Q Q Q Q
R
R
G
INTERFACE
R
H
R
I
R
R
J
AUTO
1.00
Length
Margin
●
●
●
●
●
●
●
●
●
●
●
®
or
Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q Q
HELSINKI
A
AUTO
Font
Width
Size
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
