Brother P-touch PT-9600 Guía De Usuario página 75

9 Select the desired baud rate, and then click
the Next button.
NOTE
Normally "9600 bps" is selected; however, your
computer may not be able to support a baud rate of
9600 bps. If this is the case, refer to the computer's
instruction manual, and select the maximum possi-
ble baud rate.
A dialog box confirming the settings
appears.
0 Check that the baud rate will be changed as
desired, and then click the Next button.
NOTE
To change the settings, click the Back button, and
9
return to step .
A dialog box appears, showing that the
baud rate has been changed as specified.
Ch. 4 Advanced Functions
A Click the Finish button. A dialog box
appears, showing that installation is fin-
ished.
B Click the Finish button.
NOTE
If a dialog box appears, explaining that the com-
puter should be restarted, select the option for
restarting the computer, click the Finish button to
restart the computer, and then remove the CD-
ROM from the computer.
Serial (RS-232C) mode
After the PT-9600 is connected to a computer
using an RS-232C cable, the P-touch must be set
to Interface mode in order for it to be able to
communicate with the computer.
To enter/exit Interface mode
(RS-232C connection):
● Hold down d and press 0.
1 2 3 4 5 6 7 8 9 A B C D E F K Q Q Q Q Q
R
R
G
INTERFACE
R
H
R
RS ONLINE
R
I
R
J
AUTO 1.10
Length Margin
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q
HELSINKI A AUTO
Font Width Size
61