Brother P-touch PT-9600 Guía De Usuario página 45

Tape Length function
(T. LENGTH)
Although the length of the printed label auto-
matically adjusts to fit the length of the entered
text, there may be times when you will want to
make a label with a specific length. The Tape
Length function allows you to set the label
length between 0.25" and 38.84" (0.6 cm and
99.5 cm).
The current Tape Length setting is shown in the
lower-left corner of the display.
1 2 3 4 5 6 7 8 9
R
R
G
<<< P-touch >>>
R
N O
H
R
L M
R
I
1:_
R
J
AUTO 1.10
Length Margin
NOTE
The Tape Length setting is only applied to labels
printed on TZ tape. The label length of AV labels
cannot be adjusted.
To change the setting for the Tape Length
function:
1 Hold down d and press 1.
NOTE
This step may be skipped if settings for several Glo-
bal Format functions are being applied at the same
time.
2 Press j or k until T. LENGTH is dis-
played. The current setting is shown on the
left side of the display.
1 2 3 4 5 6 7 8 9
R
R
G
10/13
R
H NO
R
T. LENGTH
L
R
I
M AUTO
R
J
AUTO 1.10
Length Margin
3 Press m or g until the desired setting is
displayed, or use the number keys to type in
the desired tape length.
K Q Q Q Q Q
A B C D E F
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q
HELSINKI A AUTO
Font Width Size
K Q Q Q Q Q
A B C D E F
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q
HELSINKI A AUTO
Font Width Size
NOTE
☞
To return the function to its default setting
(AUTO), press the space bar.
☞
To change the setting in 0.1" (1.0 cm) steps,
hold down either m or g, and then release
the key when the desired setting is displayed.
☞
The tape length is displayed in the currently
selected unit of measurement (inches or centi-
meters). The unit of measurement can be
changed with the Setup functions. (Refer to
page 68.)
☞
To return to the text without changing the for-
e
matting, press
1
press ).
4 Press n to apply the setting.
NOTE
To apply several format settings at the same time,
continue pressing j or k to select the function,
then pressing m or g to select the desired setting.
Press n only after the necessary functions have
been set.
Block Margin function
(B. MARGIN)
The width of the margins between text blocks
can be set between 0.00" and 12.00" (0.0 cm
and 30.0 cm). The left and right margins for
each text block will have a width that is the
specified setting. If the AUTO setting is selected,
the block margins will be 0.00" (0.0 cm) if only
one text block has been created and 0.13" (0.3
cm) if multiple text blocks have been created.
To change the setting for the Block Margin
function:
1 Hold down d and press 1.
NOTE
This step may be skipped if settings for several for-
mat functions are being applied at the same time.
2 Press j or k until B. MARGIN is dis-
played. The current setting is shown on the
left side of the display.
Ch. 3 Functions
d
(OR hold down and
31