Brother P-touch PT-9600 Guía De Usuario página 87

ERROR MESSAGE
LINE LIMIT!
XX LINES MAXIMUM
MEMORY FULL!
MIN 4 DIGITS!
NO FILES!
NO TAPE!
REPLACE BATTERIES!
SET 1/4" TAPE!
SET 6mm TAPE!
CAUSE
● This message appears if you try
to print or use the Layout Pre-
view function when the number
of lines in the text is greater
than the maximum possible for
the installed tape.
● This message appears if you try
to print or use the Layout Pre-
view function when the number
of lines in the text is greater
than the maximum possible for
the installed tape. (Since the
number of lines possible
depends on the width of the
tape, the message that appears
depends on the tape width.)
16 LINES MAXIMUM (on 36 mm tape)
13 LINES MAXIMUM (on 24 mm tape)
10 LINES MAXIMUM (on 18 mm tape)
6 LINES MAXIMUM (on 12 mm tape)
4 LINES MAXIMUM (on 9 mm tape)
3 LINES MAXIMUM (on 6 mm tape)
● This message appears if you try to
store a text file after the maximum
number of characters has already
been stored in the memory.
● This message appears if less
than the minimum four digits
are entered as the barcode data.
● This message appears if no files
are stored in the memory when
you try to recall, delete or print
one.
● This message appears if no tape
cassette is installed when you
try to feed the tape, print or use
the Layout Preview function.
● This message appears when the
installed Ni-MH battery is about
to run out, or when the battery
has reached a high voltage.
● This message appears if a 1/4"
(6-mm)-wide tape cassette is not
installed when printing an Auto
Format template created for 1/4"
(6-mm)-wide tape.
ERROR MESSAGE LIST
SOLUTION
● Reduce the number of
lines or install a wider
tape.
● Delete an unwanted file to
make space for the new
one.
● Enter a minimum of four
digits before pressing n.
● Store a text file before try-
ing to recall, delete or
print one.
● Install a tape cassette and
try again.
● Replace the battery or use
the AC adaptor.
● Install a 1/4" (6-mm)-wide
tape cassette.
73