Installation With Gas Cooktops; Prepare Downdraft Housing - Thermador Masterpiece Serie Manual De Instalación

I N S T A L L A T I O N

Installation with gas cooktops

Dimension "BT" is thickness of
the backsplash. Provide 1/2"
(13 mm) clearance between the
vent cutout and the backsplash.
Any backsplash with a curved
radius where it meets the counter
will require additional clearance.
Thicker backsplashes may be used by
increasing the counter and cabinet
depths.
Set the cooktop into the coutertop
opening so that the back edge of the
cooktop overlaps the leading edge of
the downdraft.

Prepare downdraft housing

1. Place the downdraft on its back on a table or l at work surface.
UPPER
SUPPORT
BRACKETS
DISCHARGE
COVERS
NUTS
(KEEP)
2. Detach the upper support brackets from the downdraft by cutting off
the tie wraps. Remove and set aside both support legs from sides of
the downdraft (one leg per side).
Note: Discard the retaining screws, but KEEP THE NUTS.
Remove the bundle of 3 dischage covers from the bottom of the
downdraft.
Page 14
Downdraft cutout width:
30" (762 mm) is 27-1/16" (687 mm)
36" (914 mm) is 33-1/16" (840 mm)
BT
MIN.
1/2"
(13 mm)
1-7/8" (48 mm)
SUPPORT
LEG
NUT
(KEEP)
SCREWS
(DISCARD)
Template
2-1/8" (54 mm)
1-1/16"
(27 mm)
Cooktop cutout width
Measurements in inches (mm).
3. Cover the discharge openings that won't be used for ducting.
Note: Use the nuts previously removed for side discharge covers.
24-11/16" (627 mm)
22-5/16" (567 mm)
19-1/8" (486 mm)