Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
8 Quick installation guide for ACSM1-04 drive modules
Connect the control cables
1. Route the cables to the control unit as shown below.
2. Ground the shields of the control cables at the clamp plate.
3. Connect the conductors to the appropriate detachable terminals of the control unit.
See section
contain any stray strands.
Note: Keep any signal wire pairs twisted as close to the terminals as possible.
EN
DE
ES
FI
FR
IT
1.5 N·m (13 lbf·in)
NL
RU
SV
TR
ZH
xx
xx
Default I/O connections
2
on page
9.
Use shrink tubing or insulating tape to
3
Publicidad
Tabla de contenido
