Pause And Serve Feature - Krups ESPRESSO COMBI XP1600 Manual Del Usuario

Putting in the ground coffee
1. Swing out the filter holder (6) and insert a paper filter in the filter basket. We recommend
using size #4 paper filters. When inserting a paper filter make sure the seam is pointing
toward the base of the filter holder (7).
Use your hands to conform the filter to the contours of the filter basket. This will allow you
to achieve better results.
2. Put ground coffee into the filter basket (8). We suggest using one KRUPS measuring
spoon of ground coffee for each cup of robust brewed coffee. You can adjust the quantity
to suit your own taste.
We do not recommend using coffee that is ground to a powder-like consistency, as this
will prevent water from passing through the filter.
3.Close the filter and make sure that it is completely closed (9).
!
ATTENTION :
Make sure that the filter paper does not fold over when closing the swivel filter,
otherwise the water might run between the filter paper and the filter holder producing
a very weak cup of coffee.
Filling the Water Chamber
1. Open the hinged lid (10). Pour in the desired quantity of water (11) and close the lid. The
amount of freshly brewed coffee delivered after the brewing process will always be slightly
less than the amount put into the water chamber. This is due to the minimal absorption
of the water by the ground coffee. The water levels on the carafe and appliance take this
absorption into account for more convenience.
2. Place the glass carafe with lid in position on the warming plate.
3. Push the "coffee" button to turn on the coffee side of the appliance. The indicator light
will illuminate indicating that the brewing process has begun.
4. As long as the blue indicator light is illuminated the coffee will be kept warm.

Pause and Serve Feature

The Pause and Serve feature automatically stops the flow of brewed coffee through the
filter cone if the glass carafe is removed from the warming plate during the brewing cycle.
You have about 20 seconds between the removal of the carafe and it being reinserted back
onto the warming plate.
The Pause and Serve device closes off the filter cone so effectively that there is virtually no
coffee dripping onto the warming plate. Once the carafe is replaced, the brewing process
and the flow of coffee into the carafe will resume.
!
CAUTION
If significant amounts of coffee drip onto the warming plate after the carafe has been
removed, please check the seal in the filter holder to ensure it is placed properly. If
a requirement seal is needed, please contact one of our main service centers or our
main parts center.
If the filter is overfilled with coffee grounds, it could cause the water that jets into the filter
cone to overflow between the filter and the sides of the filter cone. Be sure to use the proper
amount of ground coffee.
If blockage and subsequent dripping does occur, put the glass carafe immediately back
onto the warming plate, and allow the full brewing cycle to run its course. Do not swing out
the swivel filter until the brewing process is completed.
10