Faber INCA LUX Serie Instrucciones De Instalación página 7

Ducted Venting Installation
Top
1
(Follow these steps before attempting to install the Insert)
The Electrical Connection and Ground Cable must
be disconnected first before installation;
1. Disconnect the Electrical Connector as shown in
the figure. Depress the two tabs on the side of the
Electrical Connector using your hand and a small
flat head screwdriver and pull off.
2. Next disconnect the Electrical ground cable(green)
that is attached with nuts and screw in the upper cav-
ity of the insert. Unscrew and remove the electrical
ground nuts and washers using a 7mm small wrench
and a Philips screwdriver. Only remove the nuts and
washers on the inside of the cavity.
3. After removing the electrical ground cable nuts
and washers you can now remove the bottom frame
and set it aside.
Choose your ducting method
6"
Rear
Install the rangehood
Non Ducted - Recirculation
Requires
purchase of
Activated
Charcoal
Accessory
7