Identifi Cation; Handling - GASPARDO PRIMAVERA Empleo Y Mantenimiento

1.4 IDENTIFICATION
Each individual machine has an identifi cation plate (Fig. 1) indica-
ting the following details:
1) Mark and address of the Manufacturer;
2) Type and model of machine;
3) Unloaded mass, in Kilograms;
4) Mass full load, in Kilograms;
5) Registration of the machine;
6) Year of manufacture;
7) CE mark.
You are advised to note down your data on the form below, along
with the date of purchase (8) and the dealer's name (9).
8) ____________________
This information must always be quoted whenever assistance or
spare parts are needed.
ATTENTION
Do not remove, tamper with or make the CE mark affi xed on
the machine illegible.
Refer to the information provided on the CE mark for the
manufacturer's contact details (e.g. for requesting spare
parts, etc.).
When the machine is demolished, destroy the CE marking.

1.5 HANDLING

ATTENTION
The Customer must apply the rules envisaged in the European
Directives EEC 391/89 and 269/90 and subsequent modifi ca-
tions on the possible risks for loading and unloading operators
caused by manual handling of loads.
During handling operations wear suitable personal protection
equipment:
Overalls Gloves
If the machine is handled, it must be lifted by hooking onto the ap-
propriate holes with a suitable winch or crane of suffi cient capacity
(A-B, Fig. 2). Because of the danger involved, this operation should
be carried out by trained and responsible personnel. The mass of
the machine is on the identifi cation Plate (Fig. 1).
Stretch the rope to keep the machine level. The hook points can
be detected by fi nding the «hook» symbol (15, Fig. 4).
ATTENTION
• Packaging materials (pallets, cartons, etc.) must be disposed
of as prescribed by the existing regulations through autho-
rised disposal companies.
• Parts making up the machine must not be lifted by hooking
them up from moving or weak parts such as guards, elec-
trical runways, pneumatic parts, etc.
• Standing under suspended loads is not allowed; unautho-
rised personnel are not allowed access to the work sites; it
is mandatory to wear overalls, safety footwear, gloves and
a hardhat.
cod. G19503101
USE AND MAINTENANCE
9) ____________________
Shoes Hardhat

(2)
(3)
(5)
(7)
fi g. 1
fi g. 2
A
B
ENGLISH
(1)
(4)
(6)
B
B
A
41