Depth Of Cut Adjustment; Operating The Saw - GreenWorks 32042a Manual Del Propietário

STARTING/STOPPING THE SAW
See Figure 10
To start the saw:
Depress the lock-off button.
Depress the switch trigger.
Always let the blade reach full speed, then guide the
sawinto the workpiece.
LOCK-OFF BUTTON
If the blade comes in contact with the workpiecebefore it
reaches full speed, it could cause the sawto "kickback"
towards you, which could result inserious injury.
To stop the saw, release the switch trigger.After you
release the switch trigger, allow the blade to cometo a
complete stop. Do not remove the saw from theworkpiece
while the blade is moving.

DEPTH OF CUT ADJUSTMENT

See Figure 11
Always keep correct blade depth setting. The correct
EODGHGHSWK VHWWLQJ IRU DOO FXWV VKRXOG QRW H[FHHG 
in. belowthe material to be cut. More blade depth will
increase thechance of kickback and cause the cut to be
rough. Oneblade tooth below the material to be cut works
EHVW IRU PRVWHI¿FLHQW FXWWLQJ DFWLRQ
English(original instructions)
SWITCH TRIGGER
WARNING
INDICATOR
LEVER POINT
SCALE
TO ADJUST BLADE DEPTH
Fig. 10
Remove the battery pack from saw.
Loosen the depth adjustment lever.
Hold the base flat against the workpiece and raise
orlower the saw until the required depth is reached.
Tighten the depth adjustment lever securely.
INDEXABLE LEVERS
See Figure 12
The levers on the saw can be repositioned for the
besttightening position.
Pull the lever out from the saw and to desired position.
Push lever back in and down to lock into place.
Check to be sure the base is clamped securely.

OPERATING THE SAW

See Figures 13 - 14
It is important to understand the correct method for
RSHUDWLQJ WKH VDZ 5HIHU WR WKH ¿JXUHV LQ WKLV VHFWLRQ WR
learnthe correct and incorrect ways for handling the saw.
EN - 12
PUSH IN AND DOWN TO LOCK
PULL OUT AND UP
TO RATCHET
DEPTH
ADJUSTMENT
LEVER
Fig. 11
Fig. 12