Bevel Cutting - GreenWorks 32042a Manual Del Propietário

NOTE: Do not bind the blade in the cut.
USING THE EDGE GUIDE
See Figure 17-18
Use the edge guide when making long or widerip cuts with
the saw.
Remove the battery pack from the saw.
Place the edge guide through the holes in the saw
base.
Adjust the edge guide to the width needed.
Tighten the wing screw securely.
When using an edge guide, position the face of the
HGJHJXLGH ¿UPO\ DJDLQVW WKH HGJH RI ZRUNSLHFH 7KLV
makes for atrue cut without pinching the blade. The
guiding edge of theworkpiece must be straight for your
cut to be straight. Usecaution to prevent the blade from
binding in the cut.
WING SCREW
PLACE EDGE GUIDE
THROUGH HOLES
English(original instructions)
EDGE GUIDE
Fig. 17
LASER
GUIDE LINE
Fig. 18
EN - 14

BEVEL CUTTING

See Figures 19 - 20
The angle of cut of the saw may be adjusted to any
GHVLUHGVHWWLQJ EHWZHHQ ]HUR DQG ƒ
NOTE: :KHQ PDNLQJ FXWV DW ƒ WKH EODGH VKRXOG EH
setat full depth of cut.
:KHQ PDNLQJ ƒ EHYHO FXWV WKHUH LV D QRWFK LQ WKH VDZ
baseto help you line up the blade with the line of cut.
Align your line of cut with the inner blade guide notch on
WKHVDZ EDVH ZKHQ PDNLQJ ƒ EHYHO FXWV
Since blade thicknesses vary and different angles
requiredifferent settings, always make a trial cut in scrap
materialalong a guideline to determine how much you
should offsetthe guideline on the board to be cut.
:KHQ PDNLQJ D EHYHO FXW KROG WKH VDZ ¿UPO\ ZLWK
bothhands.
Rest the front edge of the base on the workpiece.
Depressthe lock-off button and squeeze the switch trigger
to startthe saw. Always let the blade reach full speed, then
guidethe saw into the workpiece.
BEVEL
SCALE
BEVEL ADJUSTMENT
KNOB
Fig. 19
BASE
ASSEMBLY
ƒ %/$'( *8,'( 127&+
Fig. 20
LOWER BLADE GUARD