Product Overview; Product Components; Assemble The Probe Holder - Hach sensION+ MM340 Manual De Usuario

1. Disconnect the equipment from its power source to verify that it is or
is not the source of the interference.
2. If the equipment is connected to the same outlet as the device
experiencing interference, connect the equipment to a different
outlet.
3. Move the equipment away from the device receiving the interference.
4. Reposition the receiving antenna for the device receiving the
interference.
5. Try combinations of the above.

2.3 Product overview

™
The sensION + meters are used with probes to measure various
parameters in water.
™
The sensION + MM340 meter has two measurement channels to
measure pH, ORP (mV) or ISE (concentration) with a selective probe.
Measurement data can be stored and transferred to a printer or PC.

2.4 Product components

Refer to Figure 1 to make sure that all components have been received.
If any items are missing or damaged, contact the manufacturer or a
sales representative immediately.
Figure 1 Meter components
1 Electrolyte for the probe
2 Buffer solutions (pH 4.01, pH
7.00 and pH 10.01)
3 Calibration beakers (with magnetic
bar inside)
4 Power supply
Section 3 Installation

3.1 Assemble the probe holder

Follow the numbered steps to assemble the probe holder and to connect
the magnetic stirrer.
5 Probe holder
6 Rod with o-ring
7 Probe (included with kits only)
8 Meter
English 5