UFESA AP8000 Manual De Instrucciones página 20

4
Connect the other end of the hose (handle) with
the telescopic suction tube.
5
Hold the ring on the pipe and set chosen length
putting it in or out.
6
Assemble the appropriate nozzle or brush to the
other end of the suction tube.
7
You may assemble a basket for picking up small
objects in the combination brush with small item
separator. In order to do so remove the basket cover
and insert the basket.
8
To clean hard surfaces – wooden floors, plastic
floors, ceramic tiles etc. pull out the brush by pressing
the switch on the nozzle according to the figure
9
The vacuum cleaner is equipped with an accessory
compartment. The compartment is located in the front
lid of the appliance. To open/close the compartment
lift/close the lid and take out/ put away the desired
nozzle.
10
The vacuum cleaner may be stored in a horizontal
position; in order to this, place the fastening hook of the
combination nozzle/brush into its fastening. The hose
may be left attached to the vacuum cleaner, but it is
important to pay attention not to leave it heavily bent
during storage.
11
Grab the plug (3) and pull the cord out of the
vacuum cleaner.
● Plug in the appliance.
Before operation, make sure that all
filters as well as the appropriate module
are installed in the appliance.
12
Switch on the vacuum cleaner by pressing the
"on/off" button (1).
Vacuum cleaner functions
TRADITIONAL CLEANING WITH SAFBAG
DUST BAG
Vacuum cleaner is equipped with SAFBAG bag (1 piece).
1
Press the "PRESS" button and remove the tank lid.
2
Remove the water filter module from the container
(filtration unit and partition).
The water filter module/the dry filtration
module with the SAFBAG dust bag may
only be removed and inserted when the
end of the hose is removed from the vacuum
cleaner opening.
3
Insert the dry filtration module with the SAFBAG (21)
dust bag to the container.
● Prepare the vacuum cleaner for operation
according to section
It is strictly prohibited to vacuum without
the dust bag and the inlet filter or with
a damaged dust bag. It may cause
a failure of the vacuum cleaner motor.
SAFBAG dust bag disassembly/assembly
.
● Remove the dry filtration module with the SAFBAG
(21) dust bag from the container.
The water filter module/the dry filtration
module with the SAFBAG dust bag may
only be removed and inserted when the
end of the hose is removed from the vacuum
cleaner opening.
1
Pull the SAFBAG dust bag interlock fastening and
pull the interlock aside.
2
Pull the fastening which attaches the SAFBAG dust
bag to the basket to release the dust bag plate.
3
Remove the dust bag.
4
Insert the SAFBAG dust bag so that the lower part
of the bag plate is in the slot of the housing. Press the
upper part of the bag plate to the fastening until you
hear a characteristic click and close the SAFBAG dust
bag interlock.
● Insert the dry filtration module with the SAFBAG (21)
dust bag to the container.
VACUUM CLEANING WITH THE USE OF
THE WATER FILTER MODULE
1
Press the "PRESS" button and remove the tank lid.
2
Insert the partition to the grooves in the container
C
so that the shutters are directed downwards. Make sure
the partition is correctly mounted in the container i.e. the
partition fins should cover the protrusion in the container.
3
Fill the container with 1,2 liter of water. The water
level should be in the range marked on the tank wall.
Do not operate the appliance with an
empty container while vacuum cleaning
with the use of the water filter module.
4
Insert the filtration unit to the tank, make sure
that the two air stub pipes are in the openings of the
vacuum cleaner body.
B
.
D
E