Setting Up The Wifi Connection (Seca 797); Setting The Wifi Function - Seca 787 Instrucciones De Uso Y Garantía

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4.7 Setting up the WiFi connection (seca 797)

Setting the WiFi function

26 •
To connect a barcode scanner to the display unit, proceed as follows.
1. Remove the cover panel:
a) Unscrew 2 cross-head screws
b) Remove the cover panel
2. Connect the barcode scanner:
a) Plug the USB connector of the barcode scanner into the USB
interface of the display unit
b) Route the barcode scanner cable over the strain relief
NOTE
Some barcode scanner cables are very thin and are thus not
adequately held in place.
► Additionally fix the barcode scanner cable in the bores on the strain
relief using a cable tie.
3. Hang the barcode scanner in the barcode scanner bracket.
4. Fit the cover panel:
a) Insert cover panel
b) Place and tighten 2 cross-head screws
1. Switch on the measuring station (➔ "Switching on the device", page 28).
2. Select the
menu item (➔ "Navigating in the menu", page 34).
rF
3. Confirm your selection.
4. Select the
menu item.
SYS
5. Confirm your selection.
The current setting is displayed.
6. Select the desired setting:
Option
On
OFF
Effect
WiFi function is activated with power supply
operation, is deactivated with battery operation
WiFi function deactivated

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

797

Tabla de contenido