Using The Machine - EMAK EF63C/6,5M Manual Del Operador

HOW TO USE THE MACHINE

5.4 USING THE MACHINE

5.4.1 S
TARTING THE ENGINE
DANGER!
!
well-ventilated area! ALWAYS REMEMBER THAT EXHAUST GASES ARE
TOXIC!
To start the engine:
1. sit on the seat and press the brake pedal right down (☛ 4.3);
2. put the transmission into neutral («N») (☛ 4.4);
3. disengage the blade (☛ 4.6);
4. when starting from cold, put the accelerator lever in the «CHOKE» position
shown on the label (☛ 4.12 - 4.22). Alternatively, if the engine is still hot, posi-
tion the lever between «SLOW» and «FAST»;
➤
In the electric start models
5. put in the key and turn to «ON» to make electrical contact, then turn to
«START» to start the engine;
6. release the key once the engine has started;
➤
In the manual start models
5. take the starter cable handle and firmly tug it.
6. once the engine has started, put the handle back in its seat.
7. After the machine has run for a few seconds, put the accelerator lever on
«START» and then on «SLOW».
IMPORTANT
the engine is already warm can foul the spark plugs and cause the engine to
run erratically.
NOTE
to avoid flooding the engine or running down the battery (if present).
– Check that the conditions allowing the engine to start are met
– Turn the key (
«OFF». Wait for a few seconds and repeat the start operation. Should the
malfunction persist, refer to chapter «7» of this manual and the engine
manual.
All starting operations have to be effected in an open or
he choke must be closed as soon as possible. Using it when
If you have difficulty starting, do not make several attempts
➤
electric start) or the accelerator (
➤
manual start) to
EN 19