EMAK EF63C/6,5M Manual Del Operador página 73

EN 34
6.4.3 E
LECTRIC AND PROTECTION SYSTEM
➤
In the electric start models:
The electric system and the electronic card
are protected by a fuse. When it blows the
machine stops, so in this case:
1. tighten the two screws (1) that fasten
the box (2) containing the card, and hold
up the lower part to prevent it from fal-
ling;
2. remove the lid (3) and pull out the card
(4) slightly;
3. replace the fuse (5) with another one of
6.3 A (delayed).
4. always put the lid (3) back on and refit
the box (2) in its correct position.
IMPORTANT
type and ampere rating, and never with one of another rating.
If you cannot find out why the fuse has blown, consult a Licensed Service
Centre.
➤
In the manual start models:
The electric system and the card are not protected by any fuses. If the safety
system fails to work properly or there are engine problems due to the electric
system, contact a Licensed Service Centre.
6.4.4 R
EPLACING THE BELT
The belt replacement must be carried out at a Licensed Service Centre.
NOTE
wear! ALWAYS USE GENUINE REPLACEMENT BELTS!
A blown fuse must always be replaced by one of the same
Replace the belts as soon as they show obvious signs of
MAINTENANCE
1
2
4
(6.3 Amp)
3