possible.
B The picture size will also change when
correction of keystone distortion is
carried out.
B The range of keystone correction varies
depending on the type of signal being
input (including when no signal is being
input). If you make an adjustment that is
outside the allowable range, the setting
will not be changed. In addition, if the
input signal changes after keystone
correction has been carried out, the
correction setting may be cancelled.
This indicates that the current correction
setting exceeds the allowable range for
the new input signal.
B If you correct both vertical and horizontal
keystone distortion at the same time, the
allowable range of keystone correction
becomes smaller. If you make an
adjustment that is outside the allowable
range, the setting will not be changed.
B The ratio of length and width of an
image may become incorrect depending
on the amount of the keystone
correction.
OSD POSITION
Press the I or H buttons to move
the OSD position.
ASPECT
This setting is only valid for an S-
VIDEO/VIDEO signal and a YP
signal in 525i (480i), 525p (480p)
and 625i format.
AUTO
4:3
16:9
S4:3
AUTO
(S-VIDEO only)
When an S1 video signal is input to
the S-VIDEO terminal, the aspect
42-E
NGLISH
ratio is changed automatically to
project a 16:9 picture.
4:3
The input signal is projected without
change.
16:9
The picture is compressed to a ratio
of 16:9 and projected.
S4:3
The size of the input signal is
compressed to 75% and projected.
(This is useful for projecting a picture with
a 4:3 aspect ratio onto a 16:9 screen.)
P
B
R
When using the 16:9 screen
When a
squeezed
signal is being
input. (The
projected
[
image is
contracted
vertically)
When a 4:3
[
signal is being
input